No custom programming is required.įor more information on loading the program and using the configuration interface, refer to online help answer ID 1000660. Updates occur in real time to ensure your room reflects the latest configuration. The program provides an XPanel configuration user interface where the HDMI inputs of a supported Crestron A/V switcher device can be mapped to virtual buttons on the Cisco Touch 10. The Crestron and Cisco® Touch 10 Routing and Control Program is loaded to the program slot of a Crestron RMC3 or RMC4 control system (or one of ten program slots if Modular Programming Architecture is enabled, allowing up to ten Cisco rooms to be controlled by a single control system 1). The Crestron and Cisco® Touch 10 Routing and Control Program requires no custom programming and can be scaled to easily configure thousands of Cisco rooms through the provided user interface. The Crestron and Cisco® Touch 10 Routing and Control Program is a program that allows Crestron® A/V switcher devices to be integrated into a Cisco room control solution and controlled via the Cisco Touch 10 touch screen, increasing the available HDMI® inputs within the room.